![Switzerland - Helicopter Mountain Tour Across Snow Peaked Summits](https://www.sensorwell.at/wp-content/uploads/2019/05/istock-1009688334.jpg)
![](https://www.sensorwell.at/wp-content/uploads/2019/11/document-ce1a2edd-b44a-1903-754401f0aba5cf95-6.jpg)
Sensorwell
060-1542-11G
Model S Subminiature; Flush Diaphragm Pressure Transducer; 100 psi to 15,000 psi; Flush-Mount Design; 17-4 PH Stainless Steel, Wetted Material; High Frequency; mV/V Output; 1 % Accuracy
Honeywell’s full line of subminiature pressure transducers accurately measure pressure ranges from 100 psi to 15000 psi. These gauge-only, subminiature pressure transducers have a high natural frequency and utilize a flush diaphragm that is manufactured from 17-4 PH stainless steel. Temperature compensation is accomplished by using temperature-sensitive components located inside the transducers. These transducers have a small electrical, zero balance circuit board that is in the lead wire (approximately 1 in x 0.087 in thick). This balance board does not have to be in the same temperature as the transducers. All transducers have four (4) active bonded strain gauges arranged in a Wheatstone-bridge configuration.
![Team Of Engineers Holding Meeting In Factory](https://www.sensorwell.at/wp-content/uploads/2019/05/istock-1014151516.jpg)
060-1542-11G
Produkt Merkmale
Kenndaten
- 100 psi to 15000 psi range
- Flush mount design
- No internal dead volume
- High frequency
- mV/V output
- CE approved
Anwendungsbereiche
- Engine and transmission test stands
- Fluid pump pressure
- Fuel line pressure and fuel/air ratio
- Brake assembly test
- Tire manufacturing mold pressure control
- Brake and accelerometer cable test
- Air bag system fill pressure
- Pressure brake testing, hydraulic sensor: Brake pedal forces, ABS pressures
- Well stimulation
- Coil tubing
- MWD
- Wellhead measurement